|
|
|
|
PLATER’S WAX HT-210 CHARACTERISTICS
Light
tan color; five (5) eleven pound slabs per carton; 55 pounds total weight. Plater’s
Wax MT-210 is suitable for use in the following applications: Hard
Chrome Plating; Lead; Acid Copper; Indium; Gray and Sulphamate Nickel;
Silver.
NOTE: Do not use Plater’s Wax in any solution
where the temperature of the solution exceeds the melting point of the wax. APPLICATION PROCEDURE1.
Plater’s Wax HT-210 must be liquefied prior to application. Use a wax
pot that is designed for liquefying the wax or some other device that will
slowly melt the wax. The wax should be held at a temperature not to exceed 210
degrees F. 2.
Before
applying Plater’s Wax HT-210, make sure the metal part has been thoroughly
cleaned and free from grease, oils and other contaminants. The adhesion of
Plater’s Wax HT-210 could be compromised if the part is not clean prior to
applying the wax. 3.
Dip the
metal part in the liquefied Plater’s Wax HT-210 and withdraw slowly. To
achieve a heavier buildup, dip the part in the liquefied wax two or three times
and withdraw quickly. Remove any excess with a sharp knife and clean the area to
be plated with naphtha or some clean solvent. 4.
After
plating, remove the part and rinse thoroughly in warm water. This will aid in
the removal of the wax from the part. Peel as much of the wax as possible from
the part and save for reuse. Boiling water will aid in the removal of any
remaining wax. 5.
Place the wax that was removed from the parts back into the wax pot or
other container.
SPECIFICATIONS:
TEST METHOD MINIMUM
TYPICAL MAXIMUM Melt Point, Drop Melt, F ASTM D-127 195 Penetration, Needle @ 77 F ASTM D-1321 7 Viscosity, sus, @ 210 F ASTM D-88 104 Color, ASTM ASTM D-1500 1.0
CAUTION ALWAYS WEAR APPROPRIATE GLOVES, EYE PROTECTION AND
BREATHING EQUIPMENT. STORE PLATER’S WAX MT-175 IN A CLEAN ENVIRONMENT AWAY
FROM DIRT, DUST AND OTHER POTENTIAL SOURCES OF CONTAMINANTS. STORE BETWEEN 50
DEGREES F AND 100 DEGREES F. KEEP
CONTAINERS CLOSED WHEN NOT IN USE. OBSERVE ALL EPA, OSHA AND OTHER FEDERAL AND
STATE REGULATIONS. CUSTOMERS ARE ASKED TO EVALUATE THIS PRODUCT PRIOR TO
USE TO DETERMINE SUITABILITY FOR THEIR PARTICULAR APPLICATION. APPLICATION
PROCEDURES AND SUGGESTED USES DO NOT CONSTITUTE ENDORSEMENT OF THIS PRODUCT FOR
ANY PARTICULAR USE OR PURPOSE. ALWAYS
CONSULT MATERIAL SAFETY DATA SHEET PRIOR TO USAGE AND FOLLOW ALL STATE AND
FEDERAL REGULATIONS REGARDING MATERIAL SAFETY DATA SHEETS. EMERGENCY TELEPHONE NUMBER: 1-800-535-5053
Click here for Terms,
Conditions and Warranty.
|
|
Send mail to
orffman@sbcglobal.net with
questions or comments about this web site.
|
